Kontron TIGW1U, Руководство по эксплуатации продукта, Страница: 25 / 104

Kontron Carrier Grade Server TIGW1U
December 2009 Product Guide, rev. 1.3
25
Server Installations and Upgrades—TIGW1U server
Note: A non-skid surface or a stop behind the server may be needed to prevent the server
from sliding on your work surface.
1. Observe the safety and ESD precautions in Appendix A, “Safety Information” .
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the shipping screw from the front of the chassis on the left side (“A”), if
present.
5. While pressing down the blue button at the top of the chassis (“B”), slide the top
cover back until it stops. (“C”).
6. Lift the cover straight up to remove it. (“C”)
3.2.2 Installing the Chassis Cover
1. Place the cover over the chassis so that the side edges of the cover sit just inside
the chassis sidewalls, with the front of the cover with about a 1/8-inch (3-mm) gap
between the chassis cover and the sheet-metal at the front of the chassis.
2. Press down slightly on the chassis cover behind the peripheral area and slide the
cover forward until it clicks into place.
3. (Optional) Install the shipping screw.
4. Reconnect all peripheral devices and the power cord.
Caution: This unit must be operated with the top cover installed to ensure proper cooling.
3.2.3 Removing the Front Bezel
Note: Hold the bezel in place while you loosen the screws. After both screws are loosened,
the bezel drops from the chassis.
1. Remove the left-side screw. (“A” in Figure 11 )
2. Remove the right-side screw to release the bezel.
Figure 10. Removing the Chassis Cover
A
B
C
TS000201