Kontron TIGW1U, Руководство по эксплуатации продукта, Страница: 20 / 104

TIGW1U server—Features
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
20
2.7 Hard Disk Drives
The TIGW1U server chassis provides three hot-swappable hard drive tray assemblies at
the front of the chassis.
For information on how to install these drives, see Section 3.3.1, “Installing or
Replacing a Hard Drive” .
Note: The TIGW1U server does not support all SAS hard drives. For a list of validated hard
drive manufacturers and hard drive types, see the Tested Hardware and Operating
Systems List (THOL) on the Kontron support website at
http://us.kontron.com/support/.
( Search for TIGW1U, click on Product Downloads, and then Compatability Matrix.)
Each drive can consume up to 17 W of power. Drives must be specified to run at a
maximum ambient temperature of 45° C.
2.8 Riser Card Assembly
The TIGW1U server default riser card assembly contains a PCI-X riser card. There is
also a PCI Express (PCIe) version available as a separately orderable accessory.
The S5000PHB server board implements a PCI super slot that contains the signals
necessary for a PCI/PCI-X or PCIe expansion slot. One of two different low-profile riser
cards is inserted into the super slot to access the appropriate signals and provide the
appropriate connector for a PCI/PCI-X or PCIe riser card. (See Figure 7 for this
location.) The Carrier Grade Server TIGW1U is designed to accommodate full-length,
full-height PCI add-in cards with the card’s I/O bracket accessible through an opening
in the rear panel of the system.
The PCI/PCI-X riser card supports speeds of 33 or 66 MHz PCI and 100 or 133 MHz
PCI-X.
The PCIe riser card implements a x8 link interface, and can be used with add-in cards
that implement x1, x4, or x8 interfaces.
See Section 3.4.5 , “Installing or Replacing a PCI Add-in Card” for how to install a PCI
add-in card or how to replace the default PCI-X riser card assembly with a PCIe version.
2.8.1 PCI/PCI-X Riser Card
The PCI/PCI-X riser card, which is the default riser card installed in the assembly,
supports one 3.3 V 64-bit slot and speeds of 33 or 66 MHz for PCI and 66, 100, or
133 MHz for PCI-X. The bus speed varies from 66 MHz to 100 MHz depending on the
I Dual-port LAN connector X BIOS Bank Select jumper (J1G1)
J Dual USB 2.0/RJ45 serial port B connector Y Intel
®
ESB2-E I/O controller hub
K Telco alarms connector Z CMOS Clear jumper (J1F1)
L Video connector AA BMC Force Update jumper (J1E3)
M PS/2 keyboard and mouse connector BB 3-Pin IPMB header
N FBDIMM slots CC Processor select jumper
O Intel
®
500P Memory Controller Hub (MCH) DD
Intel
®
Remote Management Module 2
(Intel
®
RMM2) connector
Item Description Item Description