Kontron FlexPAC, Руководство пользователя

Страница: 88 / 137

The CD-ROM Status LED
The LED indicator, on the CD-ROM, lights up continuously during the seek
cycle and during the transfer of read data to the host. It flashes while the audio
is being played (if applicable). The LED also flashes while the CD-ROM is
completing the following tasks.
1. From POR (Power-On Reset) to the end of TOC (Transfer of Contents) read
2. From tray loading to the end of TOC read (when CD is present)
3. From POR until the end of detecting the CD (no CD present)
4. From tray loading until the end of detecting the CD (no CD present)
5. If a CD error occurs, flashing continues until the CD is ejected. If there is a
hardware problem, flashing continues until the power is switched “Off.”
Manual Ejection of the CD-ROM Disk
The FlexPAC must be powered “On” for normal CD insertion and removal. If
you need to eject a CD during a power failure, or some other type of
mechanical failure, it can be done manually by hand. First, disconnect the
power cord. Then, carefully insert a straightened paper clip or similar thin
pointed tool into the emergency “Manual Eject Hole.” It is located to the right
of the LED on the frontpanel of the CD-ROM drive (see Figure 4.5,Item7).
Push the paper clip inwards until it stops with a click, and the CD-ROM tray
will then eject out.
4
■
Display & Drives
4.9