Konica Minolta REGIUS SIGMA2, Руководство по эксплуатации

Страница: 9 / 76

9
Introduction
Page Layout
27
Chapter 3
3 .3 ● Image Read Operation
The following steps explain how to read exposed plate
images with this device .
CAUTION
• Make sure not to pinch your fi ngers while inserting the
cassette .
• If an X-ray generating device is positioned near this
device, do not emit X-rays while this device is operat-
ing .
1
Prepare a cassette with an image reading
plate loaded .
If there is a memo between the cassette’s memo
clip, remove it . If there is a sticker etc . attached to
the cassette, remove it .
CAUTION
• Only cassettes specially made for this device can be
used .
2
Insert the cassette in the cassette inser-
tion slot .
CAUTION
• Do not insert anything other than the cassette in the
cassette insertion slot . Doing so may cause a malfunc-
tion .
If a foreign object has fallen inside of the device, con-
tact Konica Minolta technical representatives .
Position the back side of the cassette facing up-
ward, and slowly slide it into place, straight and all
the way to the back, in the direction of the arrow .
Insert so that
center-sections
match.
• Image reading will begin once the ImagePilot’s
status is confi rmed.
• The Busy Lamp (blue) will blink while the Image-
Pilot’s status is being confi rmed.
• The Busy Lamp is lit during the image reading
process .
HINT
• When inserting the cassette before the ImagePilot is in
image capture standby mode, changing the ImagePi-
lot to image capture standby mode will start the image
capture process .
4
Confi rm that the Ready Lamp is blinking,
then remove the cassette .
• When removing the cassette, the device initial-
ization process will begin, and the Busy Lamp
will be lit .
• Once the initialization process has ended, the
Busy Lamp will turn off, and the Ready Lamp
will be lit .
IMPORTANT
• Do not insert the cassette during the initialization pro-
cess (while the Busy Lamp is lit) . Doing so will cause
initialization to end abnormally, and an error will occur .
When an error occurs for a read image
If an error occurs for a read image, take the following
steps. Do not resume reading with this device or expo-
sure with the image-reading plate until the issue has
been resolved .
When a white line error occurs
Condenser unit might be soiled with dust or debris .
Clean the condenser unit .
REFERENCE
• Refer to “6 .2 .4 Condenser Unit cleaning (keeping
them dust free)”(p . 61)
When other errors occur
The plate might be dirty . Clean the plate .
REFERENCE
• Refer to “6 .3 .1 Plate cleaning”(p . 63 )
Number Element Explanation Icon
Title Shows the title of the explained content. -
Warning Notice
(Signal Words)
Used to highlight important information that must be known or
followed during operation .
Refer to “1 .1 .2 Warning Notice (Signal Words)”(p . 12) for details on “1 .1 .2 Warning Notice (Signal Words)”(p . 12) for details on for details on
each type .
DANGER
WARNING
CAUTION
Steps of operation Numbered steps explaining the process of operation. -
Hint Information that may be useful during operation .
HINT
Note
Important notes for operating the machine . Details should be
carefully noted .
IMPORTANT
Reference Indicates a section of the manual for reference as needed .
REFERENCE
(Pages indicated here are for explanatory purposes, and may differ from the actual pages.)