Konica Minolta REGIUS SIGMA2, Руководство по эксплуатации

Страница: 13 / 76

13
Chapter 1
1 .2 Safety Precautions
1 .2 .1 Overall Cautions
WARNING
• Though this device is classified as Class 1 Laser
Product according to IEC 60825-1:1993+A1:
1997+A2:2001, it includes a laser unit with a maxi -
mum output of 130 mW (Class 3B) .
Under no circumstances should external panels be
removed .
Removal of panels may result in exposure to lasers
or electrocution .
Device System Laser Unit Specifications:
Class: 3B
Medium: Semiconductor laser
Wavelength: 659 nm
Max Output: 130 mW
• In the event of detection of smoke, unusual odors
or sounds, the device’s power supply circuit break-
er should be turned off immediately and the power
plug disconnected from the power outlet . Then con-
tact Konica Minolta technical representatives . Con-
tinued use under such circumstances may result in
fire.
• Do not let water, liquids, bits of metal, or other such
materials enter inside of the device . Doing so may
cause fire, electric shock, or other damage.
In the event of accidental introduction of such
foreign objects or substances into the device, the
power should be switched off immediately and the
power plug disconnected from the power outlet .
Then contact Konica Minolta technical representa-
tives .
• Do not disassemble or modify this device . Not only
will this cause the device to operate abnormally, but
may also cause fire or electric shock.
If the device is in need of repair, contact your Koni-
ca Minolta technical representatives .
1 .2 .2 Electromagnetic Wave
Cautions
CAUTION
(1) EMC Statement - The unit has been tested and
found to comply with the limits for medical de-
vices to the IEC 60601-1-2:2007. These limits
are designed to provide reasonable protection
against harmful interference in a typical medical
installation . The unit generates uses and can ra-
diate radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to other devices
in the vicinity . However, there is no guarantee
that interference will not occur in a particular in-
stallation . If the unit does cause harmful interfer-
ence to other devices, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving device .
-Increase the separation between the equipment .
-Connect the equipment into an outlet on a
circuit different from that to which the other
device(s) are connected .
-Contact Konica Minolta technical representa-
tives .
(2) EMC Statement - Take precautions against the
unit especially regarding EMC . Install and put
into service according to the EMC information
provided in the manual .
(3) EMC Statement - Do not use mobile phones or
pocket pagers in the vicinity of the unit . Use of
mobile phones or pocket pagers near the unit
can cause errors in operation due to electromag-
netic wave interference: such devices should off
in the vicinity of the unit .
(4) EMC Statement - Cable List .
-AC Power Cable (3 m)
-USB Cable (5 m, USB2 .0 High-speed mode
compatible)
(5) EMC Statement - The use of accessories, trans-
ducers and cables other than those specified,
with the exception of transducers and cables
sold by Konica Minolta, Inc . as for internal com-
ponents, may result in increased emissions or
decreased immunity of the unit .
(6) EMC Statement - Do not use adjacent to or
stacked with other equipment. If adjacent or
stacked use is necessary, confirm normal opera
-
tion in the configuration in which the unit will be
used .