Konica Minolta 7075/FORCE 75, Руководство по обслуживанию

Страница: 756 / 844

E-4
[Adjustment for skew]
Move the set position of the positioning pin at the
LCT bottom plate (Fig. 16).
Fig. 16
Screws
Positioner
V. Alteration of the Paper Size
If paper size is to be altered, go to the following
procedures.
(1) Turn ON the Main power switch.
(2) Open the LCT top door, then press the paper
loading button to lower the LCT stack plate
completely.
(3) Loosen the screw of the bottom plate to adjust
the marking line to the altered paper size and
secure it again (Fig. 17)
Fig. 17
(4) Loosen or remove the screw fixing the Paper
size setting plate to move it to the marking line
of the altered paper size, or directly adjust it to
the copy paper temporarily loaded in the LCT,
then secure it again (Fig. 18).
Fig. 18
Fig. 15
(7) After adjusting, return the Dip switch to 12-3-0
(OFF).
(5) Secure the screw fixing the Paper size setting
plate (Fig. 14).
(6) Move the Paper guide side plates on both sides
of the LCT according to the adjustment made
for the center-pinion gear, then fix again with
screws (Fig. 15).
Fig. 14