Koehler KV5000, Руководство по эксплуатации и инструкция, Страница: 20 / 34

KV5000 Instrument & Software
Operation and Instruction Manual
KV5000-Manual
- 16-
Figure 6. Inserting Base of Viscometer
Engage the viscometer tube into the assembly
by gently pushing the back tube along the timing
marks into the sensors (Refer to Figure 7). Make
sure the sensor clamps fully secure the tube. Slide
the viscometer as far down as possible for
accurate measurements.
Figure 7. Installing Viscometer
If the assembly has spring clamps, then make
sure that the clamps fully secure the viscometer
tube.
Figure 8. Viscometer Tube Completely
Inserted in the Optical Sensor Assembly.
(Optical wires are not shown for illustrative
purposes only.)
If the optical sensor assembly has a Teflon
®
retaining ring rather than the spring clip, then fully
engage the viscometer tube into the assembly and
lower the Teflon
®
retaining ring to hold the tube in
place . Refer to Figure 9.
Figure 9. Viscometer Tube Completely Inserted in the
Optical Sensor Assembly with Teflon
®
Ring. (Optical wires
are not shown for illustrative purposes only.)
To uninstall the viscometer from the optical
sensor, gently push out from the top of the back
tube slowly (indicated by arrow in Figure 10), until
the tube releases from the clamps. To avoid