17
Installation and initial startup
BlueShadow Detector 40D Instructions V7647
4.6 Computer control
The detector can be operated in three ways:
Via the pin header
Via RS-232 port
As part of a LAN, via the LAN connector of the router
All connectors for external control are located on the rear side of the
detector .
Legend
1
Serial number
2
Fan opening
3
Warranty seal
4
Power switch
5
Mains power connec-
tion
6
Pin header
7
RS-232 port
8
LAN connector
9
Integrator output
Fig. 8:
Connectors on rear side
Note:
HPLC devices from KNAUER only work with IP addresses, which
have been assigned by IPv4 . IPv6 is not supported .
This chapter describes how to set up a chromatography system in a local
area network (LAN) and how a network administrator can integrate this
LAN into your company network . The description applies to the operating
system Windows® and all conventional routers .
4.6.1 Setting up LAN
To set up a LAN, we recommend to use a router . That means the following
steps are required:
Process
1.
On the computer, go to the control panel and check the LAN
properties .
2.
Hook up the router to the devices and the computer .
3.
Set up the router for the computer network .
4.
Install the chromatography software .
5.
Switch on the device and run the chromatography software .
Configure LAN properties (see section „4 .6 .2“) .
1
2
3
4
9
6
8
7
5
Procedure
Next steps
Содержание BlueShadow Detector 40D
Страница 1: ...Detector 40D Instructions Document no V7647 HPLC HPLC...
Страница 71: ...Appendix Installation Qualification IQ...
