KiSS ORCA SPIRIT, Руководство пользователя

Страница: 108 / 124

NOTE: DO NOT push on the center of the INHALATION VALVE HOLDER (23). ONLY push on
the outer edge.
7. Turn the BOV over and press out the exhala on valve holder (22) in the same
fashion as in step 6.
8. Remove the valve holder O ‐ rings (24, 25) , and clean the O ‐ ring (24, 25) grooves
(Fig. 6) . Inspect the O ‐ rings (24, 25) for damage. If found, discard.
9. The mushroom valves (26) may be removed by grasping them at the fl ange and
pulling them straight out, snipping the retainer stem if necessary (Fig. 7) . Discard.
10. Examine the valve holders (22, 23) for cracks and other damage, discard if found.
Otherwise, wash, sani ze, and remove any debris from the valve holders (22, 23) .
11. Snip the plas c ty ‐ strap (28) that holds the mouth ‐ piece (27) , and remove the
mouthpiece (27) . Inspect the condi on of the mouthpiece (27) to ensure that it is supple
and free of any tears or corrosion. Discard if found.
12. Using a 1/8" L ‐ shaped Allen key, remove the lever screw (33) , lever (34) , and O ‐
ring (35) by turning counterclockwise (Fig. 8) . Inspect the O ‐ ring (35) for any signs of
decay. Discard if found.
NOTE: Be careful not to damage the sealing surface of the inner
METAL SPOOL (16) and BOV HOUSING (1).
13. Using your thumbs, gently press the spool (16) out of the BOV housing (16) (Fig. 9) .
14. Remove the four O ‐ rings (18, 24, 25, 29) from the grooves of the spool (16) . Discard the schedule A O ‐ rings (18, 29) .
Inspect the other O ‐ rings (24, 25) for any signs of decay. Discard if found.
15. Inspect the spool (16), O ‐ rings (18, 24, 25, 29) channels, the lever O ‐ ring (35) moun ng face, and inside the BOV housing
(1) for damage (nicks, gouges, etc.) that would prevent the O ‐ rings (18, 24, 25, 29, 35) from sealing properly. If damage is found,
the damaged part must be replaced.
Figure 6
Figure 7
Figure 8
Figure 9