KiSS ORCA SPIRIT, Руководство пользователя

Страница: 79 / 124

www.kissrebreathers.com
email: info@kissrebreathers.com phone: 1 479 739 7726 Minimum Training Standards SFN 180 R.0
10
• Appropriate selection of decompression conservatism / gradient factors for the planned dive
• Thermal constraints
3. Underwater verification
• Stop at 3-6 meters/9-19 feet on descent for leak bubble check
• Counterlung & Over Pressure Valve adjustment, if necessary
4. Mouthpiece familiarity skills
• BOV: switch between open and closed circuit
• DSV: switch to bailout system
5. Adding diluent gas/ADV familiarity skills
• ADV: Adding diluent gas and understand how it works
• BOV: Use BOV to add diluent gas to the loop – 2 ways
• Bail out second stage: Use to add diluent gas to the loop
• Dual button MAV: Adding diluent gas (if unit is shipped with this item)
6. Emergency procedures: demonstrate appropriate response to the following ; each dive should have a minimum of 2 “diver emergencies”
that the student must react to.
• Practical bailout skills: including 2 open circuit ascents from approximately 18 meter/59 feet.
• Gas shutdowns and loss of gas
• Broken hoses
• Flooded absorbent canister
• Carbon dioxide (CO
2
) breakthrough
• Low oxygen drills
• High oxygen drills
• Flooding loop
• Electronics, sensor, and battery failure
7. Practice transferring to open circuit bailout
8. Rescue skill session as outlined by the training agency
9. Use of a buoyancy control system
• Buoyancy and trim control at safety stop
• Buoyancy and trim control during dive
10. Controlling and monitoring for PPO2 levels:
• Raising/lowering PPO2
• Starting PPO2
• PPO2 monitoring every minute
• Manual Add Valve verification: static at constant depth, monitor change over several minutes
• Electronics systems monitoring for PPO2 levels (SETPOINT) and setpoint switching using manual and pre-programmed methods
when available (when the unit is equipped with an on board decompression computer that monitors sensors)
11. Electronic systems use:
• Use and adjustment of Heads Up Display, position, brightness, colour
• Use and adjustment of PPO2/depth/time display, position, brightness, colour
• Use and adjustment of decompression computer, set up/gas switching, battery verification, etc
12. Use of lift bag / DSMB and reel (where relevant and applicable)