Kingfisher KI23400 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 94 / 103

QUICK REFERENCE GUIDE: KI27400 / KI23400 SERIES 2-WAY LOSS LEST METER
KI23400/KI27400 UM-2 -
92 -
Quick Reference Guide
General Operation:
•
To remove interchangeable connector adaptor, press button
on front of case and pull off adaptor. This may be easier with
a test lead attached.
•
To turn instrument on / off, press On/Off .
•
Low battery is indicated with a battery symbol.
•
To turn back light on / off, press Backlight button.
•
To disable auto-off at turn-on , hold On/Off for 3 seconds
until ‘Perm’ is displayed.
•
To disable or activate beeping at turn-on , hold F2 then press
On/Off , “beep” displays.
•
To enter Slow Mode at turn-on , hold down F3 then press
On/Off , “tone” displays.
•
To view firmware version and instrument serial number at
turn-on , hold F4 then press On/Off .
•
To view all display segments at turn-on , press and hold
On/Off , F1 at the same time until it stops beeping.
•
To set time & date, when instrument is off, hold down
Toggle Centre then press On/Off . Press - or + to modify the
selected (flashing) item. Press Toggle Centre to change
selected item. Press F2 to save new time and date settings.
Press F1 to exit without saving new settings.
•
To enter Meter menu, press F3 .
•
To enter Memory menu, press button above [MEMORY].
•
To return to Home menu, press F1 .
Meter Menu:
•
To enter Meter menu at Home menu, press F3 .
•
To select operational λ in Meter mode, press – or + .
•
To toggle log / linear display mode, press F3 .
•
To display max and min values for absolute power and loss,
press - and + simultaneously. To return to standard display,
press - and + simultaneously again.
•
To set reference, toggle to dB mode, then hold down F2 for
3 seconds until the instrument beeps finish
•
To stop / start display update, press F4 .
•
If a test tone is detected, meter will display ‘Hz’ .
•
To store to memory press triangular button above [STORE].
•
To return to Home menu, press F1 .
Source Menu:
•
To enter Source menu at Home menu, press F1 .
•
To select operating λ, p ress - or + .
•
To turn source on and off, press Toggle Centre.
•
[Laser source only] To change power level, press and hold
F2 then use - or + (not applicable to LED sources). To toggle