Kindermann Klick & Show K-10S, Инструкция по установке и эксплуатации

Страница: 27 / 90

27
4.2
Pairing Sensor-button with Base-unit
Connect the USB-connector of Sensor-button TOUCH to either of one USB port of Base-unit, to pair both units at
same WiFi. Follow all OSD messages. A successful pairing is shown at OSD and static red LED.
Then, please disconnect the Sensor-button TOUCH and use it for the mirroring on your laptop.
Pair all other buttons in the same way.
If error-message “Configuration fail” is shown, please check the connection of USB to keep stable after plug-in,
and try again.
Note:
After each changing the SSID/WiFi channel in menu, all the Sensor-buttons TOUCH must be paired again!
When you buy additional Buttons or when a Button should be assigned to another Base-unit, the Button
must be paired again.
A Button can only be paired to one Base-unit at a time. The Button will always make connection to the Base-unit it
was last paired to.