Kindermann Klick & Show K-10S, Инструкция по установке и эксплуатации

Страница: 70 / 90

70
3. Perform “Factory Reset”when the firmware update is complete?
Only when the associated “Release notes” are requiring an additional „Factory Reset“, perform it via the
menu „System Update“ / „Factory Reset”.
All data of configuration will be lost . So that you do not have to re-configure all data in an elaborate
process, therefore note all settings within the Sub-menus before doing Factory Reset.
4. The update of Base-unit is finished.
7.3 Upgrading and Pairing of Sensor-button TOUCH
1. Plug the to be updated Sensor-button TOUCH to either of the two USB port of Base-unit. It will
automatically show up a message to indicate if the installed firmware of Sensor-button is older, and needs
to be upgraded.
The upgrading progress starts automatically with the progress bar, as shown below.
2. “Pairing” to the Base-unit is done automatically afterwards.
When you get the message:
You can plug out the Sensor-button TOUCH. Update all other Sensor-buttons accordingly.