Kindermann Klick & Show K-10S, Инструкция по установке и эксплуатации

Страница: 14 / 90

14
2.1.3 Factory Reset
On pressing the Reset button, a Hardware-reset is initiated at Base-unit. A „FACTORY RESET“, can also be
performed via the menu „System Update“ / „Factory Reset”, see chapter 5.7. Both types will be set the unit
back to default.
All data of configuration will be lost . So that you do not have to re-configure all data in an elaborate
process, note all settings within the Sub-menus before doing Factory Reset.

Start up the Base-unit.

When the Home screen is shown up, press the reset button at the rear panel of Base-unit. Press this button
with a pointed object, e.g. an unbent paper clip, until the “Factory Reset” page is shown up as below, for at
least 2 seconds.

The Base-unit will reboot after 3 seconds to be default configuration.
All previous settings will be lost and you will need to do the set-up once more.
After Reset, all Sensor-buttons TOUCH must be paired again to Base-unit, because SSID has changed
(see chapter 4.2).