Keysight Infiniium 8000 Series, Руководство по обслуживанию

Страница: 34 / 162

Chapter 2: Preparing for Use
To verify basic oscilloscope operation
34
To verify basic oscilloscope operation
1
Connect an oscilloscope probe to channel 1.
2
Attach the probe to the probe compensation output on the front panel of the
oscilloscope.
Use a probe grabber tip so you do not need to hold the probe. The probe compensation
output is marked with a square wave symbol.
Figure 2-16
3
Press the Default Setup key on the front panel.
The display will pause momentarily while the oscilloscope is configured to its default
settings.
4
Press the Autoscale key on the front panel.
The display will pause momentarily while the oscilloscope adjusts the sweep speed and
vertical scale. You should then see a square wave with an amplitude of approximately
1.1 Vpp at about 700 to 800 Hz. If you do not see the waveform, ensure your power
source is adequate, the oscilloscope is powered- on, and the probe is connected securely
to the front- panel channel input BNC and to the probe calibration output.
5
Move the mouse around on the mouse surface and verify that the on- screen
mouse pointer coincides with the mouse movement.
Probe Compensation
Output