Keysight E36200 Series, Руководство пользователя

Страница: 32 / 249

Rear outputs connections
SHOCK HAZARD
Turn off AC power before connecting wires to the rear panel. All wires and straps must be properly connected
with the terminal block screws securely tightened.
Disconnect the connector plug to make your wire connections. The connector plug accepts wires sizes from AWG
12 to AWG 30. The connector plug is 20 A rated for the E36231A, E36232A, and E36234A; and 41 A rated for the
E36233A. Wire sizes smaller than AWG 20 are not recommended. Connect the load wires to the + and - terminals.
Connect the sense wires to the +s and -s terminals.
Securely fasten all wires by tightening the screw terminals. Insert the connector plug into the back of the unit. A
chassis ground binding post is located next to the fan ventilation hole for ground connections.
Part number information for the connector kit is provided under Standard Shipped Items .
Wire sizing
FIRE HAZARD
Select a wire size large enough to carry short-circuit current without overheating (refer to the following table).
To satisfy safety requirements, load wires must be heavy enough not to overheat while carrying the short-cir-
cuit output current of the unit.
AWG Suggested maximum
current (A)
1
mΩ/ft mΩ/m
12 41 1.59 5.2
14 32 2.53 8.3
16 22 4.02 13.2
18 16 6.39 20.9
20 11 10.2 33.3
22 7 16.1 52.9
24 3.5 25.7 84.2
Notes:
1. Single conductor in free air at 30 °C with insulation
32 Keysight E36200 Series User's Guide