D3DP 3xx/x
Mounting and installation instructions
Project engineering manual V1.00
26
© KEBA
●
Encoder connector
●
Connectors for motor
●
Connector brake resistor
●
Supply connectors
●
Equipotential bounding lines
RTEthernet (RJ45) connectors
If an (RT)Ethernet cable is led outside of the cabinet, the isolation of the ca
ble must be opened ca. 2030 mm after the RJ45 plug and the cable shield
must be contacted on the designated straps (lower end of the front plate)
again. The following (RT)Ethernet connectors can be affected:
Illustration 55: Cable shield
1
... Cable shield with shield clamp
2
... Control module
3
... Supply module
4
... Cabinet
Encoder connectors
All encoder cables must be shielded. All available cables from KEBA are
listed in the appendix. For connecting thirdparty motors, equivalent cables
must be used.
Connectors for the motor
All motor cables must be shielded. All available cables from KEBA are listed
in the appendix. For connecting thirdparty motors, equivalent cables must
be used.
Содержание D3DP 3 Series
