KEB COMBIVERT P6, Инструкция по эксплуатации

Страница: 70 / 78

70
DESCRIPTION Of THE TERMINALS
6.3.6 fieldbus interface X6C
The type code (=>
„2.5 Type code“
) shows the fieldbus interface that is installed in
COMBIVERT P6.
6.3.6.1 Profibus DP
The connection is described in the installation instruction (8.021). This can be down-
loaded from www.profibus.com .
Socket D-SUb-9 PIN Signal Description
5
4
3
2
1
9
8
7
6
LD5 LD6
1 – Reserved
2 – Reserved
3 RxD/TxD-P Transmit/receive signal P
4 – Reserved
5 DGND Data reference potential
6 VP Supply voltage for terminating resistor
7 – Reserved
8 RxD/TxD-N Transmit/receive signal N
9 – Reserved
Housing – High-resistance earthed
LED Signal Light pattern Meaning
LD5 Ready
On Ready for operation
Off Not ready for operation
LD6 Data
On Data are transmitted by the PROFIBUS
Off No data transmission
Figure 53: PROFIBUS DP interface
6.3.6.2 CAN-Bus
SubD-9 connector
(male)
PIN Signal Description
5
4
3
2
1
9
8
7
6
1 Reserved Not connected here
2 CAN_L CAN-Bus signal dominant low
3 CAN_GND Not connected here
4 Reserved Not connected here
5 CAN_SHLD Capacitively earthed
6 GND Not connected here
7 CAN_H CAN-Bus signal dominant high
8 Reserved Not connected here
9 CAN_V+ Not connected here
Housing – Resistively / capacitively earthed
Figure 54: CAN-Bus interface
6.3.6.3 Further bus systems
Further bus systems are described in separate manuals.