KEB COMBIVERT P6, Инструкция по эксплуатации

Страница: 67 / 78

67
DESCRIPTION Of THE TERMINALS
6.3.3.2 Pin assignment encoder channel 2 (X3B)
Socket D-SUb-9
5 4 3 2 1
9 8 7 6
PIN Incremental encoder TTL SSI
1 A+ Input channel A CL+ Output clock signal
2
B+
Input channel B DAT+ Input data channel
3 N+ Input zero track –
4 5V Voltage output 5 V 5V Voltage output 5 V
5
24V Voltage output 24 V 24V
Voltage output 24 V
6 A- Differential signal to A+ CL- Differential signal to CL+
7 B- Differential signal to B+ DAT- Differential signal to DAT+
8 N- Differential signal to N+ –
9 COM Reference potential COM Reference potential
Housing GND Shielding of the encoder cable. Housing is connected internally to the drive controller
PE.
Figure 49: Pin assignment encoder channel 2 (X3B)
6.3.3.3 Encoder cable
General information on connecting encoder cables:
• Use encoder cable double shielded and twisted in pairs.
• Connect outside shield to GND at both ends. At the drive controller end, connect
outside shield either
- onto the shield connection rail using shield connection clamps
or
- to the housing of the SubD plug (connect inside the plug).
• Connect interior shielding at one side at the inverter to COM.
• Do not connect outside and inside shield!
GND GND
A+, A-
B+, B-
N+, N-
COM
5/24V
Figure 50: Example for wiring an encoder cable