Kaye ValProbe RT, Руководство пользователя

Страница: 29 / 168

Chapter 2: Kaye ValProbe RT Hardware
Kaye ValProbe RT User Manual 16
•
If the battery is fully drained during a study, the study is
terminated at the point the battery failed. Study data to the point
of termination is stored in the Logger and can be read once a
new battery is installed.
•
If a battery is fully drained after a study is complete, all study data
can be read once a new battery is installed.
•
If you change the battery before a study is started, you need to
re-program the Logger. Although the setup is maintained in non-
volatile memory, the Logger needs to be programmed in order to
reset its clock.
Battery Replacement
Kaye recommends that you replace the battery when there is 10% battery life
remaining. The battery percentage indicator (text color) is based on the battery
percentage value, between 0-19% in Red, 20 to 49% in Orange, and 50% to
100% in Green.
Battery replacement is a three-step process involving:
•
Removing the Existing O-ring and Battery
•
Installing the Replacement O-ring and Battery
•
Resetting the Battery Odometer
Open the Logger and Remove the Existing O-ring and Battery
WARNING! To ensure that the Logger maintains its waterproof and
pressure-tight seal, a thin coat of grease was applied to the O-
ring. The grease material is KRYTOX GL-203, and safe
handling and storage practices should be followed. KRYTOX is
a registered trademark of DuPont Chemicals. Material Safety
Data information is available from DuPont Chemicals.
•
Slide the Logger opener over the probe tip and onto the top of the Logger.
Unscrew the bottom cup while holding the opener firmly against the probe
base.
Figure 21: Open Logger
•
Remove the battery cap by pressing down on it and turning counterclockwise.
•
With the cap removed, pull the battery out of the enclosure.
•
To remove the O-ring, lift it from the groove and slide off in the direction of the
probe tip.