Kathrein UFS 903 si, Руководство по эксплуатации

Страница: 48 / 124

48
General operating instructions
First switch all receivers off at the power switch.
To confi gure the current receiver to a remote control code:
Switch on the relevant receiver. You can now use the remote control for your receiver to set a new
remote control code (the remote control code 1 is set as standard). Simultaneously press buttons:
- + + for remote control code 1
- + + for remote control code 2
- + + for remote control code 3
- + + for remote control code 4
To set the remote control in future for whatever remote control code is required, proceed as follows:
- + for remote control code 1
- + for remote control code 2
- + for remote control code 3
- + for remote control code 4
If you have another Kathrein receiver in use that was supplied with the RC 660
remote control, you can use the UFS 903 remote control to operate that other
receiver also. On the UFS 903 remote control, the codes for remotely controlling
the RC 660 begin with “5”: + = remote control code 1 for the RC 660,
+ = remote control code 2 for the RC 660, + = remote control code 3
for the RC 660 and + = remote control code 4 for the RC 660
You can use this function to allow you to operate several receivers (e.g. four UFS 903 units) using the
same remote control. You can assign each receiver its own remote control code. This pre-supposes that
the receiver was supplied with the RC 671 remote control (e.g. UFS 903) or with the RC 660 remote control
(e.g. UFS 910).