Kärcher CWB 3, Оригинальная инструкция по эксплуатации

Страница: 35 / 556

English 35
5. The following manual functions can be executed via the dis-
play while a washing program is running:
a Lock/raise dryer
b Lock/raise roof brush
c Lock/outwards movement of the side brushes
d Stop the wheel brushes
Press the "Information" button to show the program progress
display.
Interrupting the currently running program
1. Press the "Stop" button.
The program is interrupted.
2. Press the "Start" button to resume the program.
Program end
After the program has finished, the positioning light indicates
whether the vehicle should be driven forwards or backwards out
of the system.
1. Drive the vehicle forwards out of the system.
Manual mode
Manual functions can be performed with the following assem-
blies:
 Portal - move
 Roof brush - raise and lower, switch on and off
 Side brushes - move in and out, switch on and off
 Dryer - raise and lower, switch on and off
 Wheel brushes - move in and out, switch on and off
1. Select Service / Manual mode / Manual portal in the main
menu.
The menu with executable manual functions opens.
2. Select the desired assembly.
The executable manual functions are shown in yellow.
3. Start the manual function.
The selected assembly must be deselected before selecting
another assembly.
Refilling the cleaning and care agents
몇
WARNING
Danger due to chemicals
Observe the safety data sheets for the cleaning and care agents
used.
Note
Press the "General Infos" and "Cleaning agent filling levels" but-
tons on the display to display the filling levels", see General In-
fos.
The filling level display is an optional extra.
1
10 litre refill canister
2
Overflow pipe
1. Screw the refill canister onto the overflow pipe.
2. Open the corresponding cleaning or care agent container.
3. Fill the reservoir and close it again.
Shutting down
Short-term shutdown
1. End the currently running washing program.
2. Leave the main switch set to "1" so that the optional frost pro-
tection device can remain activated.
Long-term shutdown
1. End the currently running washing program.
2. Drain all water lines if frost is to be expected during the shut-
down period.
3. Set the main switch to position "0".
4. Close the water supply line.
5. Close compressed air supply line.
6. Drain the cleaning and care agents.
Shutdown via the automatic frost protection device
(optional)
ATTENTION
Damage to the system if the frost protection device is not
switched on
If frost is to be expected, take care to ensure that the main power
switch is switched on and no emergency stop buttons are actuat-
ed.
The following steps are performed automatically when the tem-
perature falls below the minimum temperature:
1. The currently running washing program is executed until fin-
ished.
2. After the washing program has finished, the hoses and nozzle
pipes of the portal are blown out with compressed air.
3. Starting of further washing programs is locked out.
Note
The system is automatically ready for operation after the danger
of frost has passed