Kärcher BD 100 R, Руководство по обслуживанию

Страница: 137 / 171

BR/BD 100/250 R BP / RI Troubleshooting
Page 137 / 171 Service Manual 08.2007
6.2.3 Lifting module (A4) and Cleaning module (A3) error messages
Module Fault
classification
Display code Action
H Error when
storing
setup parameters
in the lift module
Hy/101 1. Change menu in parameter setup.
2. Change to the setup of lift module (A4).
3. For example, attempt to change “max. speed M2/
D-S2“ to another value.
4. Leave setup, save and acknowledge.
5. Perform key switch (S0) reset.
6. If the error remains, replace A4 clone in question.
Otherwise:
7. Produce the original parameters in the setup.
K
Communications
error between
cleaning module
(A3) and head
CPU (A1)
Cy/111 1. Check if bus plugs A3/X1 and A3/X2 are connec-
ted.
2. Check if bus lines A3/X2-2, A3/X1-2, A3/X2-5,
A3/X1-5 completely contact the head CPU (A1).
3. Search/repair error in bus cables.
4. If the error remains, replace A3 clone in question.
Communications
error between lift
module (A4) and
head CPU (A1)
Hy/111 1. Check if bus plugs A4/X2 and A4/X3 are connec-
ted.
2. Check if bus lines A4/X2-2, A4/X3-2, A4/X2-5,
A4/X3-5 completely contact the head CPU (A1).
3. Search/repair error in bus cables.
4. If the error remains, replace A4 clone in question.
H
Lift module (A4)
does not receive
voltage at the
power electronic
unit
Hy/121 1. Check, if main relay (K1) is closed and if relay coil
lines are completely connected with head CPU
(A1).
2. Check fuse cut-out (F4) of lifting module and
replace, if necessary.
3. Check, if short circuit is between battery voltage
and GND behind the main relay (K1). Short circuit
must be located and repaired.
4. Check, if the battery voltage is between 14..50V.
If not, check the battery.
5. If the error remains, replace A4 clone in question.
Lift module (A4)
does not receive
12-14V control
voltage
Hy/122 1. Check if 13 – 14 V are present at A4/X2-1, in this
case replace A4 clone concerned.
2. Search for fault in bus line 1 or at A1/X4-1.