7
Installation
7.1
Opening the device
↻
Mount the device to the wall.
↻
Wipe off any moisture on the housing door frame to nullify any potential liability
this could cause.
1 Open the housing door by unlocking the upper and lower lock with the double-
bit key provided.
2 Open the housing door carefully.
»
Proceed with the installation of the device.
Open
Close
Close
Open
Fig. 16:
Open the door lock
7.2
Lay the electrical lines
The pre-punched perforations on the side-mounted housing base enable all electrical lines to be inserted properly into
the interior of the device.
1
2
3
4
Fig. 17:
Inserting the cables and installing the plinth panel
1
Plinth panel (optional)
3
Pre-punched perforation
(for cable duct [72 x 110 mm])
2
Screws for mounting (8x) (optional)
4
Side housing cover
7.3
Surveying the connection area
The connection point for the AC supply is situated inside the housing. The DC input source is also connected inside the
housing.
Powador 30.0-72.0 TL3
Page 22
EN