JVA ZLM1, Руководство пользователя

Страница: 30 / 52

Installa
tion
Page 30 © JVA Technologies Pty. Ltd. www.jva-fence.com
9 INSTALLATION
It is recommended that all installations are performed by qualified techni -
cians.
9.1 INSTALLATION STEPS
1. Read the entire ZLM1 and Energiser manuals first!
2. Design and build the fence. (Beyond the scope of this manual.) Ask your
distributor for help if required.
3. Decide where the energiser, ZLM1 and Keypad are to be mounted. If on
an external wall it should be housed within a weatherproof equipment
box, shaded from direct sun.
4. Remove the ZLM1 PCB chassis from the housing by depressing the top
mounting clip and tilting the PCB towards yourself.
5. Mount the housing by using 2 screws through the rear of the box.
The box must be mounted to a wall in such a way that both holes in
the rear of the case are against the mounting surface. Do not mount
to a conductive surface. If you do so the insolation re quired under
IEC60335.2.76 may be lost.
6. Replace the PCB chassis.
7. If using a keypad, remove the rear housing of the keypad and fix it to
the wall.
8. Wire the low voltage cables to the PCB terminals.
9. Wire the high voltage cable to the PCB terminals.
10. Set the Jumpers as required
11. Fit the input power leads to the power source.
12.
Replace the front cover (lid).
13. Turn the power source on.
14.
Arm the ZLM1 and Switch on the Energiser if used. If an LCD display is
connected, it will now show the zone voltages.
15. Find and remove any faults on the fence.
16. Test that a short on the fence puts the ZLM1 into alarm and shows a
short alarm on the keypad.
17. Test that a cut on the fence puts the ZLM1 into alarm and shows a cut
alarm on the keypad.