JVA ZLM1, Руководство пользователя

Страница: 41 / 52

Page 41
Technical I
nf
orma
tion
© JVA Technologies Pty. Ltd. www.jva-fence.com JVA ZLM1 Manual
11.2.2 To exit programming mode
To exit programming mode press *#. If left unattended the ZLM1 will time
out and auto exit after approximately 5 minutes.
11.2.3 Changing the installer PIN
The installer PIN may only be changed while in programming mode.
To enter a new installer pin, press 00 followed by the new 6 digit PIN, then
the # key.
If you cannot remember your installer or user PIN, return the ZLM1 mem
-
ory to default. To do this, remove power (Disconnect keypad bus/power
input), open the ZLM1 enclosure, remove jumper J4 and reconnect the
power for about 10 seconds. Do not forget to re-fit J4.
This will return all options to the factory set defaults.
11.2.4 Changing an Option
The options have possible values in the range of 0 to 99, some are limited
to lower maximum values.
To change an option value, first check the option number (see table below)
and then the table of values for that option. On the Keypad, press the op -
tion number followed by the required value.
For example, to change option 1 to the maximum press 0140#, the keypad
will beep twice to indicate that the command was successful. The Ener-
giser LCD will immediately show the updated value.
As the keypad bus is common to a group of Z-Series Energisers and ZLM1
units, one keypad could be used to program all connected units at the same
time. A Group containing Z-Series Energisers and ZLM1 units MUST NOT
get programmed this way as the ZLM1 contains different Option values to
the Z-Series Energisers. Each ZLM1/Energiser will need to be isolated from
the Group Wiring and programmed individually.