Jungheinrich EJE 116, Руководство по эксплуатации

Страница: 37 / 81

0606
.GB
E 8
Braking
F
The braking behaviour of the truck strongly depends on the road surface conditions.
The driver must take this into account in his driving behaviour.
Braking with the service brake:
– Raise or lower the control shaft (1) to one of the
brake positions (B).
M
The service brake is the regenerative brake. The
mechanical brake is applied only if this brake does
not reach the required deceleration.
Braking using the countercurrent brake:
– While driving, the controller (8) can be used to
switch to the opposite direction.
– The truck is braked by the countercurrent until driving in the opposite direction
takes affect.
Braking with the coasting brake
The truck is braked with the regenerative brake when the drive controller is in the 0-
position.
F
Bring the control shaft into the braking position in an emergency.
Driving at inclines
M
Transport the load pointing uphill!
Securing the truck against “rolling down”:
The brake is automatically applied with a short jolt when the drive direction switch is
set to “0” (the controller detects the truck rolling down). With the drive controller you
release the service brake and control the speed and the travel direction as desired.
7
0606
.GB
E 8
Braking
F
The braking behaviour of the truck strongly depends on the road surface conditions.
The driver must take this into account in his driving behaviour.
Braking with the service brake:
– Raise or lower the control shaft (1) to one of the
brake positions (B).
M
The service brake is the regenerative brake. The
mechanical brake is applied only if this brake does
not reach the required deceleration.
Braking using the countercurrent brake:
– While driving, the controller (8) can be used to
switch to the opposite direction.
– The truck is braked by the countercurrent until driving in the opposite direction
takes affect.
Braking with the coasting brake
The truck is braked with the regenerative brake when the drive controller is in the 0-
position.
F
Bring the control shaft into the braking position in an emergency.
Driving at inclines
M
Transport the load pointing uphill!
Securing the truck against “rolling down”:
The brake is automatically applied with a short jolt when the drive direction switch is
set to “0” (the controller detects the truck rolling down). With the drive controller you
release the service brake and control the speed and the travel direction as desired.
7