Jungheinrich EJE 116, Руководство по эксплуатации

Страница: 26 / 81

D 5
0606
.GB
Adjusting the charging curve
The charging curve can be adjusted by performing the following steps:
Starting the recharging process with integrated battery charger
– Park the truck and render it safe (refer to chapter E).
F
During the recharging operation the tops of the battery cells must be exposed to en-
sure adequate ventilation. Metal objects must not be placed on the battery. Prior to
starting the recharging operation, check all cable connections and plugged connec-
tions for visible damage. The safety instructions provided by the battery supplier and
battery charger supplier must be strictly observed.
Mains supply
Mains voltage: 230 V (±6%)
Mains frequency: 50/60 Hz (±1%)
The charger power cable (6) is laterally accessible from the outside.
– Expose the battery (refer to section 4).
– Remove insulation mat from battery, if
necessary.
– Battery plug must not be unplugged.
– Connect power plug (6) with a power
socket.
The flashing LED indicates the charging
status and/or a fault (flashing codes see
table “LED display”).
Z
If the power plug (6) is connected to the
mains, all electric functions of the truck
are interrupted (electric driving lock). No
operation of the truck is possible.
– Pull plug (6) from the power socket
and place it in the battery compartment.
Z
The recharge procedure is automatically continued after a power failure.
The recharge procedure can be interrupted by pulling the power plug and can be con-
tinued in steps.
F
The mains cable must not be damaged.
Before commissioning the truck, the battery hood must be properly closed.
Connect the battery This allows you to adjust via the
charger
Turn the setting switch to the
right to select the desired
characteristic curve If the characteristic curve is
valid, the green LED flashes
according to the set position.
If invalid, the red LED flashes.
7
D 5
0606
.GB
Adjusting the charging curve
The charging curve can be adjusted by performing the following steps:
Starting the recharging process with integrated battery charger
– Park the truck and render it safe (refer to chapter E).
F
During the recharging operation the tops of the battery cells must be exposed to en-
sure adequate ventilation. Metal objects must not be placed on the battery. Prior to
starting the recharging operation, check all cable connections and plugged connec-
tions for visible damage. The safety instructions provided by the battery supplier and
battery charger supplier must be strictly observed.
Mains supply
Mains voltage: 230 V (±6%)
Mains frequency: 50/60 Hz (±1%)
The charger power cable (6) is laterally accessible from the outside.
– Expose the battery (refer to section 4).
– Remove insulation mat from battery, if
necessary.
– Battery plug must not be unplugged.
– Connect power plug (6) with a power
socket.
The flashing LED indicates the charging
status and/or a fault (flashing codes see
table “LED display”).
Z
If the power plug (6) is connected to the
mains, all electric functions of the truck
are interrupted (electric driving lock). No
operation of the truck is possible.
– Pull plug (6) from the power socket
and place it in the battery compartment.
Z
The recharge procedure is automatically continued after a power failure.
The recharge procedure can be interrupted by pulling the power plug and can be con-
tinued in steps.
F
The mains cable must not be damaged.
Before commissioning the truck, the battery hood must be properly closed.
Connect the battery This allows you to adjust via the
charger
Turn the setting switch to the
right to select the desired
characteristic curve If the characteristic curve is
valid, the green LED flashes
according to the set position.
If invalid, the red LED flashes.
7