JUMO dTRANS T06 Ex, Руководство по эксплуатации

Страница: 101 / 124

13 Error messages
101
13.3 Diagnostics channel
Display Origin Cause/remedy
Voltage 3 V Internal device Error detected when measuring the 3 V voltage supply
Restart device/return device.
Voltage 5 V Internal device Error detected when measuring the 5 V voltage supply
Restart device/return device.
Signal analog output Internal device Analog output signal deviates from the specification of the safety channel.
This may be caused by an "open" analog output (without load).
Note:
Error is only reported if the deviation occurs for more than 5 seconds.
Remedy:
h
Check load at analog output
h
In the configuration level -> Service -> Reset error -> yes
If this error is rectified, the analog output once again delivers valid values.
A restart also results in a reset of the error.
Voltage analog output Internal device Error detected when measuring the analog output voltage supply.
Restart device/return device.
Software versions Internal device The software versions of the safety channel and diagnostics channel do not
match. Restart device/return device.