JUMO dTRANS T06 Ex, Руководство по эксплуатации

Страница: 33 / 124

6 Safety manual 33
6.2 Validity of the safety manual
6.3 Special operating statuses
6.3.1 Behavior after a power failure
Analog output issues
≤
3.6 mA.
Once the mains voltage has been restored, the device starts as described in Chapter 5 and converts the measured value at the
analog input into the configured output signal.
6.3.2 During setup data transfer
(LED lights up red and green simultaneously ) The device is
switched to a safe state until the setup data reaches the de-
vice and the data has been compared.
Note
The evaluation described in this safety manual in terms of functional safety and display of certificates is valid for
the specified transmitter in SIL operation, including probe versions.
v
The connection of RTD temperature probes with 2, 3, and 4-wire technology (variant 1) or double thermocou-
ples (variant 2) is described in the safety manual for RTD temperature probes and thermocouples for connec-
tion to the JUMO dTRANS T06 type 707075.
The probes must also have been qualified for use in the Ex area.
v
All the specifications below in this chapter refer to connection variant 3