User's Guide _______________________________________________________________________
116 ______________________________________________________________________________
Enabling/Disabling Relays
You can deactivate the relay outputs for example for service purposes
of your system.
Setting Relay Outputs
NOTE
When having only one relay module installed, its relays are called
'relay 1' and 'relay 2'.
When having two relay modules, the relays of the module connected
to slot
MODULE 1
are called 'relay 1' and relay 2' and relays
connected to slot
MODULE 2
are called 'relay 3' and 'relay 4'
0706-003
Figure 61
Relay Indicators on Display
The following number refers to Figure 61 oben:
1
=
Lists enabled relays. Activation state shown in black.
Disabled relays are not shown.
Use the display/keypad to set the relay outputs.
1.
Press any of the arrow buttons to open the
MAIN MENU
.
2.
Select
Interfaces
, confirm by pressing the ►arrow button.
3.
Select
Relay outputs
, confirm by pressing the ►arrow button.
4.
Select
Relay 1/2/3/4
, confirm by pressing the ►arrow button.
5.
Select the
Quantity
, confirm by pressing
Change
. Select the
Quantity by using the arrow buttons. Confirm your selection by
pressing
Select
.
6.
Select
Act. above / Act
. below. Press SET to confirm your
selection. (If asked, select
MODIFY
if you want to set the
setpoint by using the arrow buttons. Select
REMOVE
if you
want to remove the setpoint.)
