Judo JUV 10 G, Инструкция по установке и эксплуатации

Страница: 51 / 64

Installation and operating instructions: JUDO UV disinfection system JUV 10-110 G/GS
All rights reserved. JUDO Wasseraufbereitung GmbH
© JUDO Wasseraufbereitung GmbH
Postfach 380

D-71351 Winnenden
Translation into foreign languages and reproduction, even in excerpt form, is only permitted with special
approval.
Tel. +49 (0)7195-692-0

Fax +49 (0)7195-692-188
Revision level: 03.05.2017
E-mail: info@judo.eu

Internet: www.judo.eu
51
7 Commissioning
Attention
Prerequisite for commissioning is the correct installation of the JUDO disinfection
system plus all system components!
The UVC lamp is designed for continuous operation and thus achieves the greatest
disinfection effect. Frequent switching on and off reduces its standby time.
Operating the UVC lamp in an empty radiation chamber or with flow disabled will result
in an increased temperature after only a few minutes and damage system components.
The commissioning must only be performed by JUDO customer service or authorised
technical personnel!
The transfer confirmation (see Chap. 10.7) must be carefully filled out upon
commissioning!
Observe the separate installation and operating instructions of other devices and
systems!
7.1 Initial commissioning
Attention
After initial commissioning, the water downstream of the UV disinfection system must
be discharged into the drain for at least 10 minutes.
During initial commissioning, it must be ensured that
- no visible damage is present on the JUDO disinfection system or its system components,
- all connections are checked for leak-tightness,
- the electrical connections are correctly made,

Fill the radiation chamber with water by slowly opening the shut-off valve on the supply line of the UV
disinfection system.

If there is no automatic air vent, open the vent screw slightly and completely vent the radiation
chamber.
 Close the vent screw and check the radiation chamber’s flange connections, quartz tube and UV
sensor connection for tightness.

If everything is tight you can completely open the inlet and outlet shut-off valves.