JR ProPo xg8, Руководство по эксплуатации

Страница: 48 / 92

47
PROGRAM MIXING 1-6
Each Function in the Function List
Function Explanation
In the situation where a mixing movement is required that is not incorporated in the transmitter, six
program mixing systems are provided for use. In the case where mixing is desired that is not
provided in the transmitter, the mixing can be freely structured. For this mixing, either simple normal
mixing or curve mixing that allows setting of a curve using multiple points can be selected.
•
Setting Method
Because this will be initially set to INH, select Normal mixing or Curve mixing.
【 PROG.MIX1~6 】
・Each of the Master and Slave channel name display and switch names of the Switch
Selection screen will be different for each model type.
・If the CLR key is pressed when the Master or Slave channel is shown in inverse
display, this function will return to INH and the setting will be cleared.
・In helicopters, the function will be switched ON and OFF, rather than having two
positions. Because the specification will carry out ON/OFF using the selected switch,
the screen display will be different.
Actually operate the servos and carefully confirm the settings before flying.
Caution Item
Hints
•
* Depending on the channels that
were selected for the Master and
Slave, the Sub-Selection screen of the
included function (INCLUDE) will be
displayed. In this screen, select the
required element and click on “-OK-”.
●
Normal Mixing Screen Page 1 Example of an Airplane
First, select the Master Channel for inputting the mixing, and the Slave Channel to which the mixing
will be applied. For both, the types that can be selected will be different depending on the model.
Then separately set the mixing amount in each direction. For this mixing, the setting can memorize
two positions. By setting a switch, switching between these positions can be carried out.
●
Normal Mixing Screen Page 2
Helicopter
Airplane
Glider
Sub-Selection Screen
Display Example
The mixing reference point can be offset from the Master Channel. The reason is to allow
movement of the branching point of the Page 1 left/right (up/down) direction. Further,
switching using the throttle stick position will also be possible.
Mixing Reference Point Offset Setting
Mixing Position Display
Master Channel and
Slave Channel Selection
To Switch Selection
Screen
Each Position Mixing
Amount Setting
Stick Switch Boundary Value Setting
(Only provided for airplanes.)