JR ProPo xg8, Руководство по эксплуатации

Страница: 34 / 92

33
SNAP ROLL
Each Function in the Function List
Function Explanation
This is a function for easily carrying out Snap Rolls. There are four types of presets, and normally operation is
carried out using the Snap switch. However, Stick switches are also incorporated that automatically enter a
Snap Roll when the stick is operated by a fixed amount. Further, it is also possible to select in which Flight
Modes the Snap switches will be effective.
•
Setting Method
First, release the INH setting and switch to the function screen. Rotate the dial to select the items, then
press the dial to display the setting box.
Initially, select the 4 types of presets. In the situation where the Stick switches are to be used, set the values
for each control surface where the switches will switch ON. When stick operations exceeding these values
are satisfied simultaneously, the Snap Roll will be implemented. In order to use the Snap switch, “SNAP
SW” on Page 2 should be set to “ACT”. In the situation where the Flight Mode switch has been set, this will
be displayed at the right of the screen. If this is set to “ON”, the Snap switch will be effective regardless of
the Flight Mode. Set the Flight Modes in which the function will be effective.
【SNAP ROLL】
●
Page 1
•
Airplane
・Actually operate the servos and carefully confirm the settings before flying.
・In the situation where the transmitter is being used as a trainer, this
function will not operate.
Caution Items
This selects the presets.
Operation Condition
Operation Condition
This sets the conditions that set the Stick switches to ON.
“INH” means that values have not been set.
This sets the positions of each control surface when
movement has taken place.
RIGHT-DOWN
RIGHT-UP
LEFT-DOWN
LEFT-UP
Right Down Snap Roll
Right Up Snap Roll
Left Down Snap Roll
Left Up Snap Roll
S.ROLL0
S.ROLL1
S.ROLL2
S.ROLL3 L100%
L100%
R100%
R100%
U100%
U100%
D100%
D100%
L100%
L100%
R100%
R100%
AILE ELEV RUDD Initial Setting Values
●
Page 2
To use the Snap switch, this should be set to “ACT”.
This will be displayed if the Flight Mode has been
set. Set the positions in which the Snap switch will
be effective. If ON is set, the switch will be effective
in all positions.
□ means the switch is OFF, while ■ means the
switch is ON.