JR ProPo xg8, Руководство по эксплуатации

Страница: 25 / 92

24
TAIL CURVE
Each Function in the Function List
Function Explanation
This is the mixing between the pitch and the tail servo. It is also known as revolution mixing. It allows
setting of the mixing amounts separately up and down from the hovering point. Intermediate points can
also be established in each direction, so that setting can be freely carried out. In addition, Mixing Rate
setting, which is convenient for detailed adjustment of stunt positions, will also be possible. A maximum of
5 types of setting curves can be set in each Flight Mode.
•
•
Setting Method
Input and Output Points
The numerical values of each point
can be set.
The initial input setting points are
three points set to the slow, center,
and high sides. To add a point, set
the stick to the desired position and
press the “ADD” key. In the situation
where the point is to be deleted, this
should be carried out using the “DEL”
key. The figure shows the situation
where the number of points has
been increased to 5.
When switching to this screen, for safety reasons you will be asked whether all servos should be fixed. After confirming this,
the screen will change to the Setting screen. In the situation where the servos have been fixed, in order to exit from the
Adjusting screen the throttle stick should be set to the slow side, and the Flight Mode should be set to “NORM”.
•
When using the Tail Lock Gyro (Heading Lock), this function will not be required since the tail will be
automatically corrected.
Each of the setting values must be set to zero.
Caution Items
Caution
Input Pitch Correction
The pitch information that is input to the mixer can be selected from the following two types.
“NORM”: This is the stick position referenced to the curve set using the Pitch Curve function.
“ORIG”: This is the stick position itself.
Mixing Rate in Stunt Mode
This display will be shown when the Flight Mode is set to stunt positions. It means that even though the
graph and output figures will remain the same, an action will be implemented that reduces the actual
mixing amount by the multiplier described below. Accordingly, it will allow more detailed adjustment.
However, it will become the stunt mode common multiplier.
「
1/1
」：×1
「 1/2 」：×0.5
「 1/4 」：×0.25
「 1/10 」：×0.1
•
【TAIL CURVE】
Adjusting Point
Display
This changes the Point
Connections to a Curve
Numerical Display of the Stick Input
Position and Output Position
Current Flight
Mode Position
Each Adjusting Point Input
Position and Output Position
Point Addition
and Deletion
This copies the Curve
Helicopter
Current Flight Mode
Pitch Input Correction
Mixing Rate