Johnson Controls Tyco KT-1, Руководство по установке, Страница: 16 / 56

Compatibility using Linux
The controller is compatible with the following EntraPass editions 8.20 and later:
• EntraPass Special Edition
• EntraPass Corporate Edition
• EntraPass Global Edition with a Multi-site Gateway, a Global Gateway, or a KT-NCC Network
Communications Controller
Note:
To upgrade the KT-1 controller to Linux firmware, you must have EntraPass 8.30 or
later.
For information about setting up the controller with EntraPass, see System setup with EntraPass .
Configuring IP communication
To configure the controller's IP settings, use one of the following options:
• KT Registration web page
• KT-Finder stand-alone application
For more information, see Configuration .
Communication ports
The following table lists the controller's communication ports.
Table 5: KT-1 communication ports
Controller Quantity Port Use
KT-1 and KT-1-PCB 1 10/100Base-T
(ETH1) PoE+
To get a network connection with the
EntraPass Gateway.
KT-1 and KT-1-PCB 1 RS-485 (COM1) To communicate with EntraPass or a loop of
controllers.
KT-1 and KT-1-PCB 1 RS-485 (COM2) To communicate with ioSmart card readers.
KT-1-PCB 1 RS-232 To communicate and integrate with third
party systems.
Note: In UL listed installations, this is
only for supplementary use.
IP connectivity with or without PoE/PoE+
When you use the KT-1 controller with EntraPass Special Edition, Global Edition, or Corporate
Edition, it can gather its configuration through an IP connection over a local area network (LAN) or
over a wide area network (WAN).
Note: Do not use a WAN configuration with EntraPass Global Edition.
When you use the KT-1 controller with any EntraPass edition, the first controller becomes a
master controller and can poll up to 31 controllers. The KT-1 controller is compatible with all of
the controllers. The controller asynchronously polls the KT-100, KT-300, or KT-400 controllers and
communicates with the EntraPass gateway only when it is necessary. This reduces the amount of
bandwidth that you require to operate the security system on the network.
Note: The KT-100 is not a UL listed model; do not use it in UL listed applications.
PoE provides up to 13 W power to the unit. PoE+ provides up to 25.5 W power to the unit. To power
the controller, use only a PoE, PoE+ or an external power supply source. For more information, see
Power supply .
AES encryption 128-bit
When you use the controller over the internet on a WAN or a LAN, the controller uses AES 128-bit
encryption to communicate with the gateway.
14
KT-1 One-Door Controller Installation Guide