SECTION 3 - CHASSIS & TURNTABLE
3-42
31215031
3.14 SWING DRIVE
Roll, Leak And Brake Testing
Torque-Hub units should always be roll and leak tested before
disassembly and after assembly to make sure that the unit's
gears, bearings and seals are working properly. The following
information briefly outlines what to look for when performing
these tests.
NOTE:
The brake must be released before performing the roll test.
This can be accomplished by either pressure testing using
the Brake Leak Test procedure below or by tightening the 12
bolts into the piston through the end plate (See Brake Dis-
assembly Procedure).
NOTE:
Bolts must be removed while performing brake release test.
Roll Test
The purpose of the roll test is to determine if the unit's gears
are rotating freely and properly. You should be able to rotate
the gears in your unit by applying constant force to the roll
checker. If you feel more drag in the gears only at certain
points, then the gears are not rolling freely and should be
examined for improper installation or defects. Some gear
packages roll with more difficulty than others. Do not be con-
cerned if the gears in your unit seem to roll hard as long as
they roll with consistency. Release the pressure at the Brake
Housing (6) and remove the test fixtures.
Leak Test (Main Unit)
The purpose of a leak test is to make sure the unit is air tight.
You can tell if your unit has a leak if the pressure gauge reading
on your air checker starts to fall after the unit has been pressur-
ized and allowed to equalize. Leaks will most likely occur at the
pipe plugs, the main seal or wherever o-rings or gaskets are
located. The exact location of a leak can usually be detected by
brushing a soap and water solution around the main seal and
where the o-rings or gaskets meet on the exterior of the unit,
then checking for air bubbles. If a leak is detected in a seal, o-
ring or gasket, the part must be replaced, and the unit
rechecked. Leak test at 10 psi (0.7 bar) for 20 minutes.
Brake Test
The brake test must be performed with the Motor removed
and the Brake Test Plate (T-214404) installed. Install the Hex
Bolts through Brake Test Plate and torque to 80 - 100 ft. lbs.
(108-135 Nm). Install Roll Checking Tool (T-212731) and apply
210 psi (14 bar) to the o-ring port in the side of the Brake Hous-
ing. The roll checking fixture should roll freely. Increase the
pressure to 3000 psi (207 bar) and perform the Roll Test.
NOTE:
Failure to perform this lest may result in damaged or inef-
fective brake parts.
Tightening and Torquing Bolts
If an air impact wrench is used to tighten bolts, extreme care
should be taken to ensure that the bolts are not tightened
beyond their specified torque.
The following steps describe how to tighten and torque bolts
or socket head capscrews in a bolt circle.
1.
Tighten (but do not torque) bolt “A" until snug.
2.
Go to the opposite side of the bolt circle and tighten bolt
“B” until equally snug.
3.
Crisscross around the bolt circle and tighten remaining
bolts.
4.
Now use a torque wrench to apply the specified torque
to bolt “A”.
5.
Using the same sequence, crisscross around the bolt cir-
cle and apply an equal torque to the remaining bolts.
Go
to
Discount-Equipment.com
to
order
your
parts