SECTION 3 - CHASSIS & TURNTABLE
31215031
3-93
107
0
752
1-3-6
Air filter differential pressure; air filter
clogged.
Pressure loss above target range, air filter
clogged or defective, sensor not working,
connection cable damaged.
Pressure value above warning threshold.
Check air filter and if necessary clean or renew it,
check cabling, check sensor and if
necessary replace it, check connection cable
and if necessary, repair or replace it.
110
0
92
2-2-5
Physical range check high for coolant tem-
perature.
Suspected components:
- wiring harness
- coolant temperature sensor
Check wiring harness and connected coolant
temperature sensor.
110
1
93
2-2-5
Physical range check low for coolant tem-
perature.
Suspected components:
Wiring harness.
Coolant temperature sensor.
Check wiring harness and connected coolant
temperature sensors.
110
3
96
2-2-5
Sensor error coolant temperature; Signal
range check high.
Short cut to power supply or open load.
Check sensor and if necessary replace it, check
connection cable and if necessary
repair or replace it.
110
4
97
2-2-5
Sensor error coolant temperature; Signal
range check low.
Voltage surveillance has found short cut to
ground at coolant temperature sensor.
Check sensor and if necessary replace it, check
connection cable and if necessary
repair or replace it.
Measure voltage at coolant temperature sensor
and replace harness if needed.
110
0
98
2-3-2
High coolant temperature; Warning thresh-
old exceeded.
Cooling temperature too high. Coolant temper-
ature above warning threshold.
Clean radiator, check fan drive, check coolant
level, check cooling system in general,
check thermostat function and check water
pump.
110
0
99
2-3-2
Coolant temperature; System reaction initi-
ated.
Coolant temperature above shut off threshold.
Clean radiator, check fan drive, check coolant
level, check cooling system in general,
check thermostat function, check water pump.
111
1
101
2-3-5
Coolant level too low.
Coolant level too low, leakage in cooling sys-
tem, sensor defective, wiring damaged.
Check coolant level, inspect cooling system for
leakage and if necessary repair it,
check sensor and wiring.
157
3
877
1-4-7
Sensor error rail pressure.
Sensor voltage above upper limit.
Short cut to battery.
Damaged rail pressure sensor.
Check cabling, check rail pressure sensor and if
necessary replace it,
check connection cable and if necessary repair
or replace it.
157
4
878
1-4-7
Sensor error rail pressure.
Sensor voltage below lower limit.
Short cut to ground.
Damaged rail pressure sensor.
Check cabling, check rail pressure sensor and if
necessary replace it,
check connection cable and if necessary repair
or replace it.
168
3
45
3-1-8
Sensor battery voltage error; signal range
check is high.
Battery voltage is above warning threshold
(~38,9Volt),
Short circuit to battery is possible.
Check wiring harness and connected alternator.
168
4
46
3-1-8
Sensor battery voltage error; signal range
check is low.
Battery voltage is below warning threshold,
Short circuit to ground is possible.
Check wiring harness and connected alternator.
168
2
47
3-1-8
High battery voltage; warning threshold is
exceeded.
If Battery voltage (Ubatt_U) > 17V or above
31V for more than 0.5 sec.
A warning is generated.
Battery voltage is above warning threshold.
Check wiring harness and connected alternator.
168
0
1180
3-1-8
Physical range check high for battery volt-
age.
Battery voltage over limit.
Check alternator, regulator of alternator and if
necessary replace it, check wiring and
voltage of alternator.
Table 3-11. Engine Fault Codes (Deutz Engine)
SPN
FMI
Deutz
Code
Blink
Code
Error Description
Possible Reasons For Error
Take Action For Repair (TAFR)
Go
to
Discount-Equipment.com
to
order
your
parts
