SECTION 3 - CHASSIS & TURNTABLE
31215031
3-91
94
4
473
2-1-6
Sensor error low fuel pressure, signal range
check low.
Cable break or short circuit, sensor defective or
connection cable is damaged.
Short cut to ground.
Check cabling.
If sensor is not working, check sensor and if nec-
essary replace it.
Check connection cable and if necessary repair
or replace it.
94
1
474
2-1-6
Low fuel pressure, warning threshold
exceeded.
Fuel pressure below warning threshold.
Check low fuel pressure system: Fuel feed
pump, relay, fuse, wiring, sensor.
If necessary repair or replace it.
94
1
475
2-1-6
Low fuel pressure, shut off threshold
exceeded.
Low fuel pressure, shut off threshold exceeded.
Not used.
97
3
464
2-2-8
Sensor error water in fuel, signal range check
high.
Fuel filter water level sensor: The sensor voltage
measured by ECU is out of the target
range.
Check wiring and water in fuel sensor.
Check cabling, if water in Fuel sensor is not
working, check sensor and if necessary
replace it.
Check connection cable and if necessary repair
or replace it.
97
4
465
2-2-8
Sensor error water in fuel, signal range check
low.
Fuel filter water level sensor: The voltage of sen-
sor measured by ECU is out of the
target range.
Check wiring, sensor and ECU.
97
12
1157
2-2-8
Water in fuel level prefilter; maximum value
exceeded.
Water level in fuel pre-filter reservoir over limit
(bad fuel quality).
Measure Voltage at Water in Fuel Sensor and
renew harness if needed.
100
3
732
2-2-4
Sensor error oil pressure; signal range check
high.
Short circuit to battery or cable break.
Check battery and wiring.
Check cabling. If sensor not working, check sen-
sor and if necessary replace it,
check connection cable and if necessary repair
or replace it.
100
4
733
2-2-4
Sensor error oil pressure sensor; signal range
check low.
Short circuit to ground.
The sensed raw voltage value Oil_uRawPSwmp
is above Oil_SRCPSwmp.uMin_C.
Check cabling, if sensor not working, check sen-
sor and if necessary replace it, check
connection cable and if necessary repair or
replace it.
100
0
734
2-3-1
High oil pressure; warning threshold
exceeded.
Not used.
Not used.
100
0
735
2-3-1
High oil pressure; shut off threshold
exceeded.
Not used.
Not used.
100
1
736
2-3-1
Low oil pressure; warning threshold
exceeded.
Oil pressure too low (pressure below warning
threshold).
Check oil level, check engine for oil leakage,
measure oil pressure external to evaluate sen-
sor value.
Warning threshold depending on engine
speed.
100
1
737
2-3-1
Low oil pressure; shut off threshold
exceeded.
Oil pressure too low (pressure below shut off
threshold).
Check oil level, check engine for oil leckage,
measure oil pressure external to evaluate sen-
sor value.
Shut off threshold depending on engine speed.
Table 3-11. Engine Fault Codes (Deutz Engine)
SPN
FMI
Deutz
Code
Blink
Code
Error Description
Possible Reasons For Error
Take Action For Repair (TAFR)
Go
to
Discount-Equipment.com
to
order
your
parts
