Japan Radio Co. JLR-7600, Инструкция по эксплуатации

Страница: 94 / 184

4-52
4.12.2 Setting a vessel speed alert
When the vessel speed reaches the set range, the alert is issued.
The range can be selected from OVER, UNDER, IN RANGE, and OUTRANGE.
OVER:
An alert is issued when the vessel speed reaches or exceeds the set speed.
UNDER: An alert is issued when the vessel speed is equal to or slower than the set speed.
IN RANGE: An alert is issued when the vessel speed is between the lower limit value and the upper limit
value.
OUT RANGE: An alert is issued when the vessel speed is equal to or slower than the lower limit value
or equal to or higher than the upper limit value.
For IN RANGE and OUT RANGE, set the upper limit value and lower limit value.
1. Refer to "4.15.1 Change to a maintenance mode" and display the maintenance menu.
2. Select “ALARM” and “SPEED” in this order by using
.
3. Select “OVER, “UNDER”, “IN RANGE”, or “OUT RANGE” by using .
4. Select “OVER, “UNDER”, “MAXIMUM” or “MINIMUM” by using .
5. Enter a vessel speed by using and press .
6. Set an buzzer sound and screen back light by referencing "4.12.8 Setting a buzzer sound and
screen back light”.
4.12.3 Setting a TRIP alert
An alert is issued when the TRIP distance exceeds the set TRIP distance.
1. Refer to "4.15.1 Change to a maintenance mode" and display the maintenance menu.
2. Select “ALARM” and “TRIP” in this order by using
.
3. Select “OVER” by using .
4. Select “OVER” by using .
5. Enter a TRIP distance by using and press .
6. Set an buzzer sound and screen back light by referencing "4.12.8 Setting a buzzer sound and
screen back light”.
4.12.4 Setting ARRIVAL/ANCHOR Alert
An alert occurs when own ship reaches or leaves the arrival circle set on the route.
Alerts cannot be set for both reaching and leaving.
1. Refer to "4.15.1 Change to a maintenance mode" and display the maintenance menu.
2. Press
the key to select "ALARM" and "ARRIVAL/ANCHOR" in order.
3. Press the key to select "OFF," "ARRIVAL," or "ANCHOR," and press the key.
4. Set an buzzer sound and screen back light by referencing "4.12.8 Setting a buzzer sound and
screen back light”.
Procedure
Procedure
Procedure