Japan Radio Co. JLR-7600, Инструкция по эксплуатации

Страница: 117 / 184

4-75
4.15.13 Setting the GPS Sensor Number

A number can be assigned to each GPS when there are two GPS sensors.

This number used for Remote Maintenance System data, so always perform GPS number
configuration.

When only one GPS is used, set the number to No1.

Set a number for each display type, main and sub. Sub-display are not connected to GPS sensors,
but must be set.

Always set numbers in order starting from No1.
1. Refer to "4.15.1 Change to a maintenance mode" and display the maintenance menu.
2. Press
the key to select "RECEIVER No."
3. Press the key to select the number, and press the key.
4.15.14 Outputting setting value
Setting value can be output to an external unit.
Data is output from a data IN/OUT1 port.
If data IN/OUT1 is set to reception, the port must be set to transmission.
Connect PC to a serial port before output operation.
1. Refer to "4.15.1 Change to a maintenance mode" and display the maintenance menu.
2. Refer to "4.15.5.1 Setting transmission" to set DATA IN/OUT1 to "SEND."
3. Press
the key to select "INTERFACE" and "DIAGNOSIS" in order.
4. Select "CONFIG OUT" and press the key. Setting value is output to an external unit.
Procedure
When DATA IN/OUT1 is used by setting to transmission, port setting is not required. At
completion of alert history, the setting is reset to the original output data automatically.
Supplement
Procedure