27
9. Offset coulter mounts are used in areas or hinges that dont allow a direct mount. Offset coulter mounts are
updated and look like the image below on the right. It can offset to the left or right and also mount a coulter
at the base and on its extention if necessary. Mount coulter 5 to the front of the wing with an offset mount
(shown in red below). Coulter 5 is the only coulter on the wings that is mounted on the front. Offset coulter
mounts use (2) 5/8”-11 x 7-1/8” x 8-11/16” square U-bolts with (4) 5/8” Gr2 Z lock washers and (4) 5/8”-11 Gr2 Z
hex nuts. If there is a coulter mounted in the center of the offset then you will use (2) 5/8”-11 x 7-1/8” x 10-1/4”
square U-bolts. If you have something in the way using a U-bolt you will use 5/8” x 3-1/2” bolt and 5/8” serrated
flange hex nut to fasten the coulter rod in those instances. Minimum of 3 U-bolts needed if the second coulter
is in the center.
10. Mount coulter 10 to the back of the wing with an offset mount (shown in red below).
{
45cm
{
45cm
Offset coulter
mounts
5
4
3
5/8"-11 x 7-1/8" x 8-11/16"
Square U-Bolt
5/8"-11 x 7-1/8" x 10-1/4"
Square U-Bolt
5/8"-11 x 7-1/8" x 10-1/4"
Square U-Bolt
10
11
9
8. Mount coulter 2 from the opposite direction as coulter 1.
Coulter 2 uses the wider channel bracket (JM0054464) plate to
get around the weldments (shown below). Use (2) 5/8”-11 x
7-1/8” x 8-11/16” square U-bolts to mount the wider channel
bracket plate, and (4) 5/8” x 3-1/2” bolt and 5/8” serrated flange
hex nut to fasten the rod of the coulter.
1
2
Coulter Mounting - 45cm Row Spacing
