31
8. Continue to measure 70cm across the tool bar to place coulters.
Offset coulter mounts are used in areas or hinges that dont allow a direct mount. Offset coulter mounts are
updated and look like the image below. It can offset to the left or right and also mount a coulter at the base
and on its extention if necessary. Mount coulter 5 to the front of the wing with an offset mount (shown in red
below). Coulter 5 is the only coulter on the wings that is mounted on the front. Offset coulter mounts use (2)
5/8”-11 x 7-1/8” x 8-11/16” square U-bolts with (4) 5/8” Gr2 Z lock washers and (4) 5/8”-11 Gr2 Z hex nuts. If
there is a coulter mounted in the center of the offset then you will use (2) 5/8”-11 x 7-1/8” x 10-1/4” square
U-bolts. If you have something in the way using a U-bolt you will use 5/8” x 3-1/2” bolt and 5/8” serrated flange
hex nut to fasten the coulter rod in those instances. Minimum of 3 U-bolts needed if the second coulter is in
the center.
3
4
{
70cm
7
6
8
{
70cm
Coulter Mounting - 70cm Row Spacing
5/8"-11 x 7-1/8" x 8-11/16"
Square U-Bolt
5/8"-11 x 7-1/8" x 10-1/4"
Square U-Bolt
5/8"-11 x 7-1/8" x 10-1/4"
Square U-Bolt
