29
8. The U-bolts for coulter 2 go through the slots in the weldment shown below. Continue to measure 50cm
across the tool bar to place coulters. Coulter 4 does not use a channel bracket plate. Instead, use (4) 5/8” x
3-1/2” hex bolts that go through holes in the toobar weldment to mount the channel bracket castings directly
to the weldment. Secure using (4) 5/8” centerlock hex nuts.
Offset coulter mounts are used in areas or hinges that dont allow a direct mount. Offset coulter mounts are
updated and look like the image below on the right. It can offset to the left or right and also mount a coulter
at the base and on its extention if necessary. Mount coulter 5 to the front of the wing with an offset mount
(shown in red below). Coulter 5 is the only coulter on the wings that is mounted on the front. Offset coulter
mounts use (2) 5/8”-11 x 7-1/8” x 8-11/16” square U-bolts with (4) 5/8” Gr2 Z lock washers and (4) 5/8”-11 Gr2 Z
hex nuts. If there is a coulter mounted in the center of the offset then you will use (2) 5/8”-11 x 7-1/8” x 10-1/4”
square U-bolts. If you have something in the way using a U-bolt you will use 5/8” x 3-1/2” bolt and 5/8” serrated
flange hex nut to fasten the coulter rod in those instances. Minimum of 3 U-bolts needed if the second coulter
is in the center.
2
4
3
5
{ {
50cm
50cm
6
9
8
7
{
{
{
{
50cm
50cm
50cm
50cm
5/8"-11 x 7-1/8" x 8-11/16"
Square U-Bolt
5/8"-11 x 7-1/8" x 10-1/4"
Square U-Bolt
5/8"-11 x 7-1/8" x 10-1/4"
Square U-Bolt
Coulter Mounting - 50cm Row Spacing
