23
4. Die grind the paint off the inside of the holes on the toolbar and the wing extensions that will have pins
inserted into them (as shown below). Die grinding makes inserting the pins easier.
5. Mount wing extensions, right side wing is JM0036122 and left side wing is JM0036129. Start on the right side
of the toolbar. Using a lift, align the holes of the wing extension with the holes in the toolbar. Use a 2-1/2”
diameter pivot pin (JM0031502) with a 3/4” x 2-1/2” Gr8 YZ hex bolt and 3/4” centerlock nut as a keeper on
each wing.
6. Insert the 2-1/2” diameter pivot pins (JM0031502). Set the bolt-mounted D-ring (JM0036703) over the pivot
pin so that it covers the retainer and the hole on the D-ring lines up with the hole on the pivot pin. Fasten
with the bolt 3/4” x 2-1/2” Gr8 YZ hex bolt facing upward so the 3/4” centerlock nut as a keeper is on top of the
toolbar (as shown below).
7. Then add the 3-1/2” x 14” outside wing fold cylinder (JM0055022) with the fittings facing up and butt end of
the cylinder towards the inside wing using 1” x 3-1/2” pins (JM0001817). Use the image and table below to
assemble to linkage for this connection.
Right
Left
Left
10
7
5
6
8
9
11
3
4
12
Description
Part No.
3
3/4”-10 Gr2 Z Centerlock Hex Nut
JM0002147
4
Dee Ring - Bolt Mounted
JM0036703
5
3/4”-10 x 2-1/2” Gr8 YZ Hex Bolt
JM0027464
6
1” x 6” Pin
JM0031495
7
Spacer Linkage 2-9/16” Long (NitroGro)
JM0031494
8
Linkage - Outside Wing (NitroGro 5000 Series)
JM0030333
9
Pivot Pin - 2-1/2” Dia with Bolt Retainer (NitroGro) JM0031502
10 1” x 3-1/2” Clevis Pin with Cotter Pins
JM0001817
11 5” Clevis Pin (1” Diameter)
JM0031496
12 Cotter Pin (for 1" Diameter Clevis Pin)
JM0003064
Toolbar
