Jamara Fokker DVII, Инструкция

Страница: 25 / 28

25
COVERING AND FINISHING THE MODEL
Place the left and right side struts on the sides of fuselage. Secu-
re the rods on the fuselage with 2x15mm tapping screws.
Top view of installing struts to the fuselage. Secure the control horn set onto the aileron of top wing.
Install the z-bend into the outmost hole of the servo arm. Adjust
the aileron toque rod length by screwing in or out until the aileron
is exactly in the neutral position when the servo is centered and
the clevis is in the aileron horn. Place a piece of silicon tube over
the clevis for avoiding accidentally coming open.
Use instant glue to secure 2 pieces of MW15 into the slots on the
center part of the bottom main wing.
Install the M3x25mm screw with 3x10mm washer into the rear
edge of the bottom main wing. Place a piece of 5mm silicon tube
on the end for avoiding missing.
Connect the servo with 30cm cable. Apply a piece of transparent
tape on the connecting place for avoiding loosing off. Connect
the plug of extension with the cotton string inside the servo tray,
and apply a piece of transparent tape to hold the conjunction in
place for temporary.
Pull the cotton string from the cable exit until the extension is
out of the main wing. Use hobby knife to remove the transparent
tape. Fit the servo into the servo tray and secure it in place with
the provided screws come with the servo. Connect the extension
with the receiver and set the neutral position.
Attach the clevis onto the horn. Use a marker; place a mark on
the unthreaded end of the pushrod where it passes the servo
arm. Use Z-bend pliers; make a z-bend at the marked location.
Cut out the excess rod around 6mm from the z-bend.
Insert the metal balls into the plastic ballends. When press the
metal ball, one end keeps short metal, another keeps longer
metal.
The longer metal end will be connected with strut. Please ar-
range the rods as the picture indicated (two long, one short and
one long in order). Use M2x10mm screws and plastic nuts to
secure the rods in location.
Repeat the same procedure and connect the rods to the right
side strut.