Jamara Fokker DVII, Инструкция

Страница: 20 / 28

20
Try to find the hole on the side of rudder (below the second hin
-
ge).
Use soldering to melt out the covering over the hole (2mm).
Place the top main wing on the working table with the back facing
upward.Try to find the pre-serving slots on the fourth rib. Use
hobby knife to cut off the covering over the slots.
Use ironer to trim the edges of the slots. Place the bottom main wing on the working table. Try to find the
pre-serving slots on the second rib.
Use hobby knife to cut off the covering over the slots. Use ironer
to trim the edges of the slots.
Place the bottom main wing on the working table. Try to find 2
pre-serving slots around the center part.
Use hobby knife to cut off the covering over the slots. Use ironer
to trim the edges.
Place the fuselage on the working table with the bottom facing
upward. Try to find 2 pre-serving slots. Use hobby knife to remo
-
ve the covering over the slots.
COVERING AND FINISHING THE MODEL
Use soldering to melt out the covering over the slots. Place the horizontal on the working table.Try to find the holes on
the elevator as the picture shown.
Use soldering to melt out the covering over the holes (2mm).