Jamara Fokker DVII, Инструкция

Страница: 6 / 28

6
Use sanding paper to trim the side edges into round edges (R5).
Try to fit DW4 to the bottom of the sub wing as the rear edge.
Drop some instant glue to secure it in place.
Completion of the sub wing and wit for apply films.
Close view of the round edges. It makes the horizontal looking
better and avoiding disturbed flow.
Place DW1 on the working table.
Place the H1 (horizontal), H4(2 pieces) and H5(2 pieces) on the
working table.
Place H2, H3, H6 and H7 on the working
table for assembling elevator.
Make sure the alignment of every ribs and every angle must be
90 degree; use instant glue to secure the joint places. Spread
some UHU glue on the joint places of DW7 with DW2 and DW3.
Try t o fit the DW1 to the sub win g as the leading edge. Make
sure the alignment of every ribs and drop instant glue to secure
ribs on the DW1.
Try to fit H4 and H5 into its relative slot on the H1. Make sure
the surface is flat and drop instant glue to secure them in place.
Place DW4 on the working table.
Use sanding paper to trim the leadingedge and uneven surface,
chamfer the rear edge.
Use sanding paper (#150-200) to trim both sides of horizontal.
Don‘t trim too much; make sure the thickness is 5mm.
LANDING GEAR SUB WING ASSEMBLY
ELEVATOR ASSEMBLY