Jamara Fokker DVII, Инструкция

Страница: 21 / 28

21
Use ironer to trim the edges of the slots.
COVERING AND FINISHING THE MODEL
Place the fuselage, 2 pieces of main gear, sub wing, 4 pieces of
plastic plates, 8 pieces of 2.6x8mm tapping screws, DW9 gauge
and rubber band on the working table for installing main gear.
Try to fit the main gears into the slots; place plastic plates over
the gear and secure the gear in place with 2.6x8mm tapping
screws.
Place the DW9 gauge on the center position of the sub wing. Use
rubber band to hold the DW9 in position for temporary.
Try to fit the main gears into the slots on the sub wing with DW9
touching the bottom of the fuselage. Use AB glue to secure the
main gear inside the slots.
Place 2 pieces of 3x280mm axles, 2 pieces of collars, 2 pieces
of M3x4 hex screws , 4 pieces of 3mm washers and 2 pieces of
100mm wheels on the working table.
Insert the axles into the slots on the sides of sub wing. Install
the washers, wheels (concave side facing outside), washers and
collars in order. Secure the collars with M3x4 hex screws.
Apply a piece of adhesive Velcro tape inside the fuselage. Insert
a piece of Hook-and-Loop through slot.
Try to find the locking rod in the hardware bag. Insert the locking
rod from one side of the fuselage (behind the canopy), through
the center slot on the latch and exit from another side of the fuse
-
lage. Drop some instant glue to secure the rod on the center slot.
Try to find 2 pre-serving slots on the center part of the horizontal. Use hobby knife to remove the covering over the slots. Try to fit the vertical into the slots. When satisfy the location, use
pen to mark the outline of the vertical on the horizontal.