Jamara Fokker DVII, Инструкция

Страница: 4 / 28

4
Try to fit the MW9 combinations onto the MW2 and MW4 like the
picture shown. Left MW9 combination must be on the left side.
Don‘t use any glue.
Top view of the left and right MW11 combinations.
Make sure the alignment of every rib and place some heavy thing
(1 KG) on themiddle edge. Place a long straight ruler on the lea
-
ding edge. Make sure the angle between the ribs and leading
edge is 90 degree. Use instant glue to secure the every joint
place on ribs.
Place MW10 (4 pieces) and MW11 (2 pieces) on the working
table.
Refer to the assemble drawing when assemble the ribs to the
bottom main wing. Try to fit the rib MW6 from the center part.
Fit other ribs MW9 (6 pieces), MW11, MW12 in order.Don‘t apply
any glue to the ribs. Fit MW2 and MW4 to the main wing and
drop small amount of instant glue to fix them in place temporary.
Drop some instant glue to secure the MW12 on the main wing
as the wing tip.
Try to fit MW5 on the main wing as the rear edge.
Use glue to secure the MW10 on both sides of MW11. Use clip
to hold them in place until the glue is dried enough. Drop some
instant glue on the edges.
Try to fit MW3 to the main wing as the middle edge and press
every ribs into its relatives slots. Don‘t apply any glue to the ribs.
Completion of left MW11 and right MW11 combinations.
Try to fit the 5mm dowel MW1 as the leading edge. Use triangle
ruler when drop instant glue to secure the dowel on the MW12.
Top view of both MW9 combinations. Place MW2, MW9 combinations and MW4 on the working table.
BOTTOM MAIN WING ASSEMBLY